Waters Autospec Premier Operator's Manual page 155

Probe control dialog box's Ramps tab
Probe Control dialog box's Ramps tab parameters
Parameter
Ramp
Rate
Value
Hold
To create probe ramping data
1. In the Value text box specify the required initial ramp value and then
press Enter.
2. In the Hold text box specify the required start time for the ramp and
then press Enter.
Description
The ramp identifying number.
The rate of the ramp, in units of Value/minute.
Displays the ramp's final target value, in units
appropriate to the probe type.
The time (in minutes) for which to hold the Value,
once it is reached.
Ramping the probe temperature 6-17