Fitting The Sample Cup To The Probe Tip - Waters Autospec Premier Operator's Manual

3. Evaporate any solvent used in loading by placing the sample cup(s) in a
warm location.

Fitting the sample cup to the probe tip

Warning:
materials. Wear nitrile gloves at all times while handling the
components.
Caution:
keep the sample cup free of grease (for example, from laboratory
surfaces) and handle with tweezers.
To fit the sample cup to the probe tip
Caution:
that it is firmly held by the sample cup holder; if the sample cup is
loose, it can become dislodged when inserting the probe in the ion
source.
Use tweezers to fit the sample cup to the sample cup holder in the end of the
probe tip.
To ensure good thermal contact with the heater, fit the sample cup firmly
Tip:
in the holder.
Sample cup
Sample cup holder
6-8 Inlets and probes
The probe components can be contaminated with toxic
To avoid contaminating the sample, after flame-cleaning,
When fitting the sample cup to the sample cup holder, ensure