Table of Contents
Advertisement
2.
Remove the 10-mm ceramic spacer from each ceramic rod.
3.
Remove the 2-mm ceramic spacer from each top ceramic rod.
Hold down the ceramic rods when removing the inner source
Caution:
contact support assembly, so that the source lens plates and
supporting ceramics do not fall apart
4.
Remove the inner source contact support assembly.
See
"Disassembling the inner source contact support assembly" on
page
7-58.
2-mm ceramic spacer
Inner source contact
support assembly
Source maintenance
7-49
Advertisement
Table of Contents
Troubleshooting
