Making The Probe Cooling Water Connections - Waters Autospec Premier Operator's Manual

See "Loading sample into the sample cup" on page 6-6 and "Fitting the sample
cup to the probe tip" on page 6-8.
Attach the probe to the ion source by means of the source side lock.
Probe in position in the source side lock

Making the probe cooling water connections

To make the cooling water connections between the probe and instrument
Connect the probe's two male cooling water connectors to the female cooling
water connectors on the instrument. The two connections are interchangeable.
Pull back the collar on the female connector while inserting the male
Tip:
connector.
The solids sample introduction probe 6-5