Waters Autospec Premier Operator's Manual page 229

5. Wrap the heater lead, fitted with the insulating ceramic, around the
shaped ceramic spacer.
Heater terminal
6. Fit the 2-mm ceramic spacer over the shaped ceramic spacer, ensuring
that the heater lead is trapped between the spacer and the heater
terminal.
7. Fit and tighten the screw and washer.
Use the "clutch pencil" tool (provided in the tool-kit) to handle the
Tip:
screw.
8. Repeat steps 1 to 7
Heater lead
for the second source heater.
Source maintenance 7-71