Customizing The Peak Trace Line Appearance; Customizing The Peak Intensity Display - Waters Autospec Premier Operator's Manual

Customizing the peak trace line appearance

You can customize the peak trace line appearance using the Trace command
in the Peak Display menu.
Some of these options can also be selected using the peak display toolbar.
Tip:
"Customizing the Tune window peak display toolbar" on page
See also:
Each trace may be displayed as:
• Outline only: click Trace > Outline.
• With the area below the line filled: click Trace > Fill.
• Maximum and minimum points only: click Trace > Min/Max.
• With the peak display update paused: click Trace > Freeze.
• With the last few traces (specified in the Customise Plot Appearance
dialog box Storage mode, Visible Traces text box) displayed: click Trace
> Storage.
A check mark is displayed beside the selected option in the Peak Display
Tip:
menu.

Customizing the peak intensity display

Check marks are displayed beside the selected options in the Peak
Tip:
Display menu.
To display the peak intensities as absolute values (counts/second):
In the Peak Display menu, click Intensity > Absolute Intensity.
To display the peak intensities as percentage values relative to the intensity
of the highest peak:
In the Peak Display menu, click Intensity > Relative Intensity.
To control the way in which the peak display is scaled:
The Peak Display menu Intensity > Normalise Data option can be selected in
conjunction with either of the previous options. It controls the way in which
the peak display is scaled. When enabled, the display scales to the value of the
intensity of the highest peak; when disabled, the display scales to the last set
value.
The Tune window peak display
D-50).
D-49