Code 2 Of 5 - Intermec Trakker Antares 2410 System Manual

Code 2 of 5

Terminals: All Trakker Antares terminals.
Description: Enables or disables decoding of Code 2 of 5 symbology. Code 2 of 5 uses
Syntax: CCdata
Default: Disabled
Menu System: Main Menu > Configuration Menu > Symbologies Menu > 2 of 5/I 2 of 5
Bar Codes: To disable Code 2 of 5, scan this bar code:
Or: To enable Code 2 of 5:
Trakker Antares 2400 Family System Manual
the bars to encode information and the spaces to separate the individual
bars. This code is discrete and self-checking.
You can only enable Code 2 of 5 if the Interleaved 2 of 5 (I 2 of 5) code is
disabled. If you enable I 2 of 5, Code 2 of 5 is automatically disabled.
Enabling Code 2 of 5 automatically disables Interleaved 2 of 5 (I 2 of 5).
where data consists of three digits as follows:
Digit 1: 0
1
Digits 2 and 3: 00
01-32
Note: Label lengths less than 3 are not supported on terminals with an
integrated E1022 linear imager or an integrated PDF417 scan engine.
Disable Code 2 of 5
*$+CC000*
*$+CC000*
1 Scan one of these bar codes:
Enter Accumulate Mode /
Enable Code 2 of 5, 3 Bar Start/Stop Code 2 of 5, 2 Bar Start/Stop
*+/$+CC0*
*+/$+CC0*
2 Scan a two-digit numeric value to set the label length (01-32) from
these bar codes.
*0*
*0*
Chapter 6—Configuration Command Reference
Code 2 of 5, 3 Bar Start/Stop
Code 2 of 5, 2 Bar Start/Stop
Disable Code 2 of 5
Label Length
Enter Accumulate Mode / Enable
*+/$+CC1*
*+/$+CC1*
*1*
*1*
145