Intermec Trakker Antares 2410 System Manual page 205

Syntax: YZn.data
Default: \x03 (hexadecimal value for ETX)
Menu System: Main Menu > Configuration Menu > Communications Menu > Serial
Bar Codes: To disable EOM for each serial port, scan these bar codes:
Or: To set EOM to one or two ASCII characters for one serial port:
Trakker Antares 2400 Family System Manual
• LRC
• Start of Message (SOM)
Note: EOM cannot equal the same value as SOM, and EOM1 cannot
equal the same value as EOM2.
EOM cannot be set to these values:
• AFF (ACK)
• DLE
• NEG (NAK)
• Poll
• RES (EOT)
where n is:
1 COM1 serial port
2 COM2 serial port (246X and 248X terminals only)
3 COM3 serial port (242X terminals only)
4 COM4 serial port (242X, 2455, and 248X terminals only)
Acceptable values for data are one or two ASCII characters.
Port
Disable EOM for COM1
*$+YZ1.*
.
*$+YZ1 *
Disable EOM for COM3
*$+YZ3.*
.
*$+YZ3 *
Note: To set this command using the bar code labels from the "Full ASCII
Bar Code Chart" on page 284, you must configure the terminal to use
Code 39 in Full ASCII mode. For help, see "Code 39" on page 146.
1 Scan this bar code:
Enter Accumulate Mode / Set EOM
*/K/O/D/KYZ*
*+/$+YZ*
Chapter 6—Configuration Command Reference
• REQ (ENQ)
• SEL
• XOFF
• XON
Disable EOM for COM2
*$+YZ2.*
.
*$+YZ2 *
Disable EOM for COM4
*$+YZ4.*
.
*$+YZ4 *
185