Intermec Trakker Antares 2410 System Manual page 227

Syntax: YM3.data
Default: 0 (auto rate)
Menu System: Main Menu > Configuration Menu > Communications Menu > Serial
Bar Codes: To set the default modem initialization sequence, scan this bar code:
Or: To set the modem dial sequence for COM3:
Trakker Antares 2400 Family System Manual
where data can be up to 25 characters from this table.
Characters for Modem Initialization Sequence
Character Description
0-9 DTMF digits 0 through 9
A-D DTMF letters A through D
* The star digit (tone dialing only)
# The gate digit (tone dialing only)
W Wait for dial tone
@ Wait for silence
& Wait for credit card dialing tone
, Pause
( Ignored. You can use this character to format the dial sequence.
) Ignored. You can use this character to format the dial sequence.
- Ignored. You can use this character to format the dial sequence.
. Ignored. You can use this character to format the dial sequence.
<space> Ignored. You can use this character to format the dial sequence.
Port [COM3]
Default Modem Initialization Sequence
*$+YM3*
*$+YM3*
Note: To set this command using the bar code labels from the "Full ASCII
Bar Code Chart" on page 284, you must configure the terminal to use
Code 39 in Full ASCII mode. For help, see "Code 39" on page 146.
1 Scan this bar code:
Enter Accumulate Mode / Set Modem Initialization Sequence
*+/$+YM3*
*+/$+YM3*
2 Scan a value for data from the "Full ASCII Bar Code Chart" on page
284. The modem dial sequence can be from 1 to 25 characters.
Chapter 6—Configuration Command Reference
207