Intermec Trakker Antares 2410 System Manual page 128

Chapter 5—Reader Command Reference
From Network:
Keypad or Menu: Not supported
Scan: Follow these steps:
108
On the host, you use a hexadecimal conversion utility to convert the 8-bit
binary file to a 7-bit ASCII hexadecimal file. Intermec has a DOS utility
called HEX.EXE to convert files. The source code for HEX.EXE is also
available. For help, see your Intermec service representative. Once the file
is converted to a 7-bit ASCII hexadecimal file, you use the Receive File
command and a host utility to transfer the 7-bit file to the terminal and
convert it back to an 8-bit file.
Note: Trakker Antares filenames are up to eight characters with a three-
character extension. Files you transfer from the host must use the Trakker
Antares naming conventions.
.%Hn,drive:filename
where:
is the command to receive a file that was converted from 7-bit
.%H
ASCII hexadecimal and convert it back to an 8-bit binary file.
The terminal uses the current serial port configuration
(protocol, baud rate, etc.) for the file transfer.
indicates the terminal's serial port: 1, 2, or 4.
n
drive: indicates the drive on the terminal where you want to receive
and store the file. You must include the colon (:) after the drive
letter.
filename is the file you want to receive and save on the terminal.
Note: To scan these bar code labels, you must configure the terminal to
use Code 39 in Full ASCII mode. For help, see "Code 39" on page 146.
1 Scan this bar code label:
Enter Accumulate Mode / Receive File
*/K/O./EH*
*+/.%H*
2 Scan the bar code label for the terminal COM port you are using to
receive the file. The label also includes the required comma.
COM1
*1/L*
*1,*
3 Scan the bar code label or labels for the file you want to receive. You can
scan labels from the "Full ASCII Bar Code Chart" on page 284. The
label must use this format:
drive:filename
COM2
*2/L*
*2,*
Trakker Antares 2400 Family System Manual
COM4
*4/L*
*4,*