Intermec Trakker Antares 2410 System Manual page 268

Chapter 6—Configuration Command Reference
Bar Codes: To set the default configuration and disable all symbology identifiers, scan
Or: To set all symbology identifiers to the ISO/IEC Standard, scan this bar
Or: To enable or disable the ISO/IEC Standard for one or more symbologies,
248
this bar code:
Disable All Symbology Identifiers
*$+CY000*
*$+CY000*
code:
Enable ISO/IEC Standard For All Symbology Identifiers
*$+CY001*
*$+CY001*
or to set a user-defined symbology identifier for one or more symbologies:
Note: If you are using firmware version 6.20 or earlier, you must set all
symbology identifiers to the ISO/IEC Standard before you can set a user-
defined symbology identifier.
Note: To set this command using the bar code labels from the "Full ASCII
Bar Code Chart" on page 284, you must configure the terminal to use
Code 39 in Full ASCII mode. For help, see "Code 39" on page 146.
1 Scan this bar code:
Enter Accumulate Mode / Set Symbology Identifiers
*+/$+CY*
*+/$+CY*
2 Scan one of these bar codes:
All Symbology IDs
*00*
*00*
Code 128
*02*
*02*
Code 93
*04*
*04*
Interleaved 2 of 5
*06*
*06*
Code 39
*01*
*01*
Codabar
*03*
*03*
Code 11
*05*
*05*
PDF417
*08*
*08*
Trakker Antares 2400 Family System Manual