Intermec Trakker Antares 2410 System Manual page 180

Chapter 6—Configuration Command Reference
Other: To disable or enable the ability to scan multiple-read labels, scan one of
160
TRAKKER Antares
2400 Menu System
*..-.*
*..-.*
Note: Accumulate mode commands are separated into two bar codes
so that the command can be accumulated rather than executed as a
command. You need to scan the following bar codes in order from left
to right.
Backspace
*-*
*-*
Clear
*-*
*-*
Enter Accumulate Mode
*+*
*+*
Exit Accumulate Mode
*-*
*-*
3 Scan one of these bar codes:
Disable the Command
*0*
*0*
4 Repeat Steps 2 and 3 to disable or enable another reader command.
Note: You can accumulate up to 250 characters in the buffer. If the data
accumulated exceeds 250 characters, you will hear an error beep and the
terminal will reject the last bar code read.
5 Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
these bar codes:
Disable Multiple-Read Labels
*$+DC0*
*$+DC0*
Transmit File
*%%*
*%%*
(continued)
*+*
*+*
(continued)
*-*
*-*
(continued)
*/*
*/*
(continued)
*/*
*/*
Enable the Command
*1*
*1*
Enable Multiple-Read Labels
*$+DC1*
*$+DC1*
Trakker Antares 2400 Family System Manual