Intermec Trakker Antares 2410 System Manual page 284

Chapter 6—Configuration Command Reference
264
4 Scan one of these bar codes to set the third digit:
Disable EAN-8
*0*
*0*
5 Scan one of these bar codes to set the fourth digit:
Supplementals Not Allowed
*0*
*0*
Supplementals Required
*2*
*2*
Five-Digit Supplementals Required
*4*
*4*
6 (Optional) Scan one of these bar codes to set the fifth digit:
Discard Check Digit
*0*
*0*
7 (Optional) Scan one of these bar codes to set the sixth digit:
Discard Number System Digit
*0*
*0*
Note: If you discard the number system digit, one leading digit is
discarded from UPC-A, UPC-E, and EAN-8, and two leading digits are
discarded from EAN-13.
8 (Optional) If you enabled UPC-A/EAN-13, scan one of these bar codes
to set the seventh digit:
Discard Leading Zero for UPC-A
*0*
*0*
9 Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Enable EAN-8
*1*
*1*
Supplementals Allowed
*1*
*1*
Two-Digit Supplementals
Required
*3*
*3*
Transmit Check Digit
*1*
*1*
Transmit Number System Digit
*1*
*1*
Transmit Leading Zero for UPC-A
*1*
*1*
Trakker Antares 2400 Family System Manual