Intermec Trakker Antares 2410 System Manual page 126

Chapter 5—Reader Command Reference
From Network:
Or:
Keypad or Menu: Not supported
Scan: Follow these steps:
106
Note: Trakker Antares filenames are up to eight characters with a three-
character extension. Files you transfer from the host must use the Trakker
Antares naming conventions.
.%Xn,drive:filename
.%Kn,drive:filename
.%Yn,drive:filename
.%Yn,drive:
where:
is the command to receive a file using XMODEM protocol.
.%X
is the command to receive a file using XMODEM-1K protocol.
.%K
is the command to receive a file using YMODEM protocol.
.%Y
indicates the terminal's serial port: 1, 2, or 4.
n
drive: indicates the drive on the terminal where you want to receive
and store the file. You must include the colon (:) after the drive
letter.
filename is the file you want to receive and save on the terminal.
Note: To scan these bar code labels, you must configure the terminal to
use Code 39 in Full ASCII mode. For help, see "Code 39" on page 146.
1 Scan this bar code label:
Enter Accumulate Mode / Receive File
*/K/O./E*
*+/.%*
2 Scan the bar code label for the communications protocol you want to
use.
XMODEM
*X*
*X*
3 Scan the bar code label for the terminal COM port you are using to
receive the file. The label also includes the required comma.
COM1
*1/L*
*1,*
Receives a file using XMODEM protocol
Receives a file using XMODEM-1K protocol
Receives a file using YMODEM protocol
Receives a batch of files using YMODEM
XMODEM-1K
*K*
*K*
COM2
*2/L*
*2,*
Trakker Antares 2400 Family System Manual
YMODEM
*Y*
*Y*
COM4
*4/L*
*4,*