Keypad Clicker; Keypad Control - Intermec Trakker Antares 2410 System Manual

Keypad Clicker

Terminals: All Trakker Antares terminals.
Description: Enables or disables the keypad clicker. The terminal sounds a click each
Syntax: KCdata
Default: Enabled
Menu System: Main Menu > Configuration Menu > Terminal Menu > Keypad
Bar Codes: Scan one of these bar codes:

Keypad Control

Terminals: All Trakker Antares terminals.
Description: Enables or disables the keypad. When you disable the keypad, you cannot
Syntax: KEdata
Default: Enabled
Menu System: Not supported
Bar Codes: Scan one of these bar codes:
Trakker Antares 2400 Family System Manual
time you press a key or decode a row of a two-dimensional symbology.
Note: If the Beep Volume command is set to off, you will not hear any
audio signals including the keyclick.
Acceptable values for data are:
0 Disable keypad clicker
1 Enable keypad clicker
Disable Keypad Clicker
*$+KC0*
*$+KC0*
use the keypad to enter information into the terminal.
Acceptable values for data are:
0 Disable keypad
1 Enable keypad
Disable Keypad
*$+KE0*
*$+KE0*
Chapter 6—Configuration Command Reference
Enable Keypad Clicker
*$+KC1*
*$+KC1*
Enable Keypad
*$+KE1*
*$+KE1*
197