Intermec Trakker Antares 2410 System Manual page 293

Trakker Antares 2400 Family System Manual
Appendix A—Default Configurations and Command Syntax
Operations Default Configuration (continued)
Operations Command
Decode Security
Display Backlight Timeout
Display Spacing
Display Contrast
Display Cursor Style
Display Font Type
Display Row Spacing
Display Video Mode
Flash Memory Configuration
Keypad Caps Lock
Keypad Clicker
Keypad Control
Keypad Type
Postamble
Preamble
RAM Drive Size
Resume Execution
Scan Ahead
Scanner Mode
Scanner Redundancy
Scanner Selection
Scanner Timeout
Scanner Trigger
Suspend/Resume Control
Symbology Identifiers
Time and Date
Time in Seconds
Time Zone
Default Value
Moderate
10 seconds
00000 (8x8 font size, no column spacing, no row
spacing)
3 (maximum contrast)
8x16 font
0
Original
0 (flash memory for double-byte fonts)
Caps lock off
Enabled
Enabled
Hardware default
No characters (disabled)
No characters (disabled)
0 (no RAM drive)
Allowed
Disabled
One-Shot mode
Normal
Specific integrated scanner installed on the
terminal (integrated scanners). All compatible
scanners (tethered scanners)
Disabled (no timeout)
Level triggering
Enabled
000 (All symbology identifiers disabled)
The date of the most recent firmware installation
or upgrade. (See note below.)
Disabled
Note: When you restore the default configuration,
Time and Date is not reset to the default value.
Time and Date only returns to its default value
when you boot the system, upgrade the firmware,
or perform a destructive reset.
8 Pacific Standard Time (PST)
273