Intermec Trakker Antares 2410 System Manual page 41

Trakker Antares 2400 Family System Manual
access point or through the Ethernet network. You use the Terminal
Message Format (TMF) protocol to send and receive transactions between
the host application and the terminal.
For more information about sending and receiving data, see "Transferring
Files and Data in a TCP/IP Direct Connect Network" on page 24.
Note: You can continue running an application on the terminal while
configuring the terminal from the host.
To set up the host computer
• Verify that you can communicate with the terminal.
To set up the application
• Prepare and write a host application that can communicate with the
terminal. Configuration commands must be sent to network port 6000
on the terminal. Message transactions to and receive transactions from
the terminal on network port 6000 must conform to the following
format:
TMF field commands
where:
TMF field is a 2-byte field containing one of these values:
CG
Cg
CS
Cs
commands are the reader and configuration commands that you
want to set on the terminal or the current value you
want to retrieve from the terminal. To save
configuration changes in flash memory, send the
reader command
For a list of commands, see Chapter 5, "Reader
Command Reference," or Chapter 6, "Configuration
Command Reference."
Chapter 2—Configuring and Managing the Terminals
Configuration Get request sent from the host
application.
Configuration Get response sent from the
terminal to the host.
Configuration Set request sent from the host
application.
Configuration Set response sent from the
terminal to the host.
as the last command.
.+1
21