Intermec Trakker Antares 2410 System Manual page 182

Chapter 6—Configuration Command Reference
Syntax: YTn.data
Default: Enabled without TMF
Menu System: Main Menu > Configuration Menu > Communications Menu > Serial
Bar Codes: To set the default for each serial port, scan these bar codes:
162
Options for Configuration Commands Via Serial Port
Option Description
Disabled All data received through the serial port is treated as data. The terminal
will not execute reader or configuration commands sent or encoded in
the data.
Enabled If the data is sent with the TMF (Terminal Message Format) header, the
with TMF terminal will check for and execute reader or configuration commands
received through the serial port. With TMF, you can execute reader and
configuration commands or send and receive data about the current
terminal configuration.
Enabled The terminal will check for and execute all reader and configuration
without commands (i.e., Receive File reader command or Beep Volume change
TMF configuration command).
Note: Before you can enable Configuration Commands Via Serial Port
with or without TMF, you must configure the EOM command.
where n is:
1 COM1 serial port
2 COM2 serial port (246X and 248X terminals only)
3 COM3 serial port (242X terminals only)
4 COM4 serial port (242X, 2455, and 248X terminals only)
Acceptable values for data are:
0 Disabled
1 Enabled with TMF
2 Enabled without TMF
Port
COM1 Commands Via
Serial Port Enabled Without TMF
*$+YT1.2*
*$+YT1.2*
COM3 Commands Via
Serial Port Enabled Without TMF
*$+YT3.2*
*$+YT3.2*
COM2 Commands Via
Serial Port Enabled Without TMF
*$+YT2.2*
$+YT2.2*
COM4 Commands Via
Serial Port Enabled Without TMF
*$+YT4.2*
*$+YT4.2*
Trakker Antares 2400 Family System Manual