Intermec Trakker Antares 2410 System Manual page 269

Trakker Antares 2400 Family System Manual
MSI
*09*
*09*
Code 2 of 5
With 2 Bar Start/Stop Codes
*11*
*11*
UPC-A
*16*
*16*
EAN-8
*18*
*18*
3 Scan one of these bar codes:
Disable Symbology ID
Symbology ID
*0*
*0*
Enable User-Defined Symbology ID
*2*
*2*
If you enabled a user-defined symbology identifier, continue with Step
4. Otherwise, continue with Step 6.
4 Scan a numeric value for the character string length of the user-defined
symbology identifier from these bar codes:
*1*
*1*
*3*
*3*
5 Scan a value for the user-defined symbology identifier from the "Full
ASCII Bar Code Chart" on page 284. The user-defined symbology
identifier should be 1 to 4 characters in length depending on the
character string length value that you scanned in Step 5.
6 Repeat Steps 3 to 6 to configure another symbology identifier.
7 Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Chapter 6—Configuration Command Reference
Plessey
*10*
*10*
Code 2 of 5
With 3 Bar Start/Stop Codes
*12*
*12*
UPC-E
*17*
*17*
EAN-13
*19*
*19*
Enable ISO/IEC Standard
*1*
*1*
*2*
*2*
*4*
*4*
249