Intermec Trakker Antares 2410 System Manual page 254

Chapter 6—Configuration Command Reference
Syntax: SAdata
Default: Disabled (no timeout)
Menu System: Main Menu > Configuration Menu > Terminal Menu > Scanner
Bar Codes: To set the default scanner timeout, scan this bar code:
Or: To set the scanner timeout:
234
Acceptable values for data are:
0 Disabled
1-60 Shutoff time in seconds
3-60 Shutoff time in seconds (decoded scanners with Scanner Trigger
set to pulse triggering)
Note: If you are using a decoded scanner, the scanner defaults to a timeout
of 3 seconds. The menu system may display the default scanner timeout
value of Disabled, however, the actual timeout is 3 seconds. Do not try to
set the scanner timeout to Disabled.
Disable Scanner Timeout
*$+SA0*
*$+SA0*
1 Scan this bar code:
Enter Accumulate Mode / Set Scanner Timeout
*+/$+SA*
*+/$+SA*
2 Scan a numeric value for data from these bar codes:
*0*
*0*
*2*
*2*
*4*
*4*
*6*
*6*
*8*
*8*
3 Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
*1*
*1*
*3*
*3*
*5*
*5*
*7*
*7*
*9*
*9*
Trakker Antares 2400 Family System Manual