Intermec Trakker Antares 2410 System Manual page 208

Chapter 6—Configuration Command Reference
Syntax: YLn.data
Default: 0 (no flow control)
Menu System: Main Menu > Configuration Menu > Communications Menu > Serial
Bar Codes: To set the default flow control for each serial port, scan these bar codes:
Or: To set the flow control for one serial port:
188
• CTS/RTS for DTE-DTE allows for peer connections. Each terminal's
RTS output pin is connected to the CTS input pin of the other
terminal. Each terminal sets RTS whenever it is ready to receive data
and waits for CTS to be set before sending data.
You can configure flow control for these communications protocols:
Binary, Configurable, and Polling Mode D. For more information, see the
networking chapter in your user's manual.
where n is:
1 COM1 serial port
2 COM2 serial port (246X and 248X terminals only)
3 COM3 serial port (242X terminals only)
4 COM4 serial port (242X, 2455, and 248X terminals only)
Acceptable values for data are:
0 No flow control
1 CTS checking
2 XON/XOFF response
3 XON/XOFF control
4 XON/XOFF response and control
5 CTS/RTS for DTE-DTE
Port
No Flow Control for COM1
*$+YL1.0*
*$+YL1.0*
No Flow Control for COM3
*$+YL3.0*
.
*$+YL3 0*
1 Scan this bar code:
Enter Accumulate Mode / Set Flow Control
*+/$+YL*
*+/$+YL*
No Flow Control for COM2
*$+YL2.0*
*$+YL2.0*
No Flow Control for COM4
*$+YL4.0*
.
*$+YL4 0*
Trakker Antares 2400 Family System Manual