Intermec Trakker Antares 2410 System Manual page 288

Chapter 6—Configuration Command Reference
Default: WEP Key 1 is set to 80211 for WEP 64.
Menu System: Main Menu > Configuration Menu > Communications Menu > Radio
Bar Codes: To set the default value for WEP key 1, scan this bar code:
Or: To set a WEP key:
268
The following value is returned:
AB<cr>AB
Note: If you use nonprintable ASCII characters using the TRAKKER
Antares 2400 Menu System, you must enter:
\xnn
where nn is the hexadecimal value of a single nonprintable character. You
may not enter a character with a value of \x00 using the menu system. For
example, to use a carriage return (0x0C) as a value in a WEP key string,
enter this value:
AB\x0xAB
The following value is returned:
AB<cr>AB
Set WEP Key 1 to 80211
*$+LM80211*
*$+LM80211*
Note: To set this command using the bar code labels from the "Full ASCII
Bar Code Chart" on page 284, you must configure the terminal to use
Code 39 in Full ASCII mode. For help, see "Code 39" on page 146.
1 Scan this bar code:
Enter Accumulate Mode
*+/*
*+/*
2 Scan one of these bar codes to set a WEP key:
Set WEP Key 1
*$+LM*
*$+LM*
Set WEP Key 3
*$+LO*
*$+LO*
Set WEP Key 2
*$+LN*
*$+LN*
Set WEP Key 4
*$+LP*
*$+LP*
Trakker Antares 2400 Family System Manual