Intermec Trakker Antares 2410 System Manual page 157

Bar Codes: To set the default baud rate for each serial port, scan these bar codes:
Or: To set the baud rate for one serial port:
Trakker Antares 2400 Family System Manual
Default Baud Rate for COM1
*$+YA1.7*
*$+YA1.7*
Default Baud Rate for COM3
*$+YA3.7*
*$+YA3.7*
1 Scan this bar code:
Enter Accumulate Mode / Set Baud Rate
*+/$+YA*
*+/$+YA*
2 Scan the serial port from these bar codes:
COM1
*1.*
*1.*
COM3
*3.*
*3.*
3 Scan the baud rate from these bar codes:
1200 Baud
*3*
*3*
4800 Baud
*5*
*5*
19200 Baud
*7*
*7*
4 Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
5 Repeat Steps 1 through 4 to set the baud rate for another serial port.
Chapter 6—Configuration Command Reference
Default Baud Rate for COM2
*$+YA2.7*
*$+YA2.7*
Default Baud Rate for COM4
*$+YA4.7*
*$+YA4.7*
COM2
*2.*
*2.*
COM4
*4.*
.
*4 *
2400 Baud
*4*
*4*
9600 Baud
*6*
*6*
38400 Baud
*8*
*8*
137