Intermec Trakker Antares 2410 System Manual page 232

Chapter 6—Configuration Command Reference
Syntax: LAdata
Default: INTERMEC
Menu System: Main Menu > Configuration Menu > Communications Menu > Radio
Bar Codes: To set the default network name, scan this bar code:
Or: To set the network name to "ANY," scan this bar code label:
Or: To set the network name to an ASCII character string:
212
associate with any access point, regardless of the access point network
name.
You can roam between access points as long as all of the RF devices have
the same network name. You can also create subnetworks in the same area
by assigning different network names to terminals and access points.
Acceptable values for data are up to 32 ASCII characters.
Default Network Name
*$+LAINTERMEC*
*$+LAINTERMEC*
Set Network Name to ANY
*$+LAANY*
*$+LAANY*
Note: To set this command using the bar code labels from the "Full ASCII
Bar Code Chart" on page 284, you must configure the terminal to use
Code 39 in Full ASCII mode. For help, see "Code 39" on page 146.
1 Scan this bar code:
Enter Accumulate Mode / Set Network Name
*+/$+LA*
*+/$+LA*
2 Scan a value for data from the "Full ASCII Bar Code Chart" on page
284. The network name can be from 1 to 32 characters.
3 Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Trakker Antares 2400 Family System Manual