Intermec Trakker Antares 2410 System Manual page 261

Menu System: Main Menu > Configuration Menu > Communications Menu > Serial
Bar Codes: To disable SOM for each serial port, scan these bar codes:
Or: To set SOM to an ASCII character for one serial port:
Trakker Antares 2400 Family System Manual
Port
Disable SOM for COM1
*$+YY1.*
*$+YY1.*
Disable SOM for COM3
*$+YY3.*
.
*$+YY3 *
Note: To set this command using the bar code labels from the "Full ASCII
Bar Code Chart" on page 284, you must configure the terminal to use
Code 39 in Full ASCII mode. For help, see "Code 39" on page 146.
1 Scan this bar code:
Enter Accumulate Mode / Set SOM
*/K/O/D/KYY*
*+/$+YY*
2 Scan the serial port from these bar codes:
COM1
*1.*
*1.*
COM3
*3.*
.
*3 *
3 Scan a bar code for data from the "Full ASCII Bar Code Chart" on page
284.
4 Scan this bar code:
Exit Accumulate Mode
*/M/O*
*-/*
5 Repeat Steps 1 through 4 to set SOM for another serial port.
Chapter 6—Configuration Command Reference
Disable SOM for COM2
*$+YY2.*
*$+YY2.*
Disable SOM for COM4
*$+YY4.*
.
*$+YY4 *
COM2
*2.*
*2.*
COM4
*4.*
.
*4 *
241