Intermec Trakker Antares 2410 System Manual page 174

Chapter 6—Configuration Command Reference
Default: Digit 1: Symbology ID disabled
Bar Codes: To enable ISBT Code 128 with the default settings, scan this bar code.
Or: To configure ISBT Code 128:
154
Digits 000-999
7-9
Digit 10 d or t
Note: The Left Data ID and Right Data ID are used only with the
restricted concatenation option. For example, the terminal will
concatenate only those bar code labels with data identifiers that match the
configured data identifiers. The spacing between bar codes that can be
concatenated must be between 2 and 5 character widths.
Digit 2: Concatenation disabled
Enable ISBT Code 128
*$+CH8*
*$+CH8*
Note: To set this command using the bar code labels from the "Full ASCII
Bar Code Chart" on page 284, you must configure the terminal to use
Code 39 in Full ASCII mode. For help, see "Code 39" on page 146.
1 Scan this bar code:
Enter Accumulate Mode / Enable ISBT Code 128
*+/$+CH8*
*+/$+CH8*
Bar code concatenation control parameters.
If digit 10 is "d," digits 7 and 8 refer to the
nominal distance in millimeters between the stop
characters of two bar code labels that can be
concatenated, and digit 9 is the bar code label
positioning tolerance. If the distance between the
two bar code labels is outside the limit set
(assuming standard ISBT bar code print size), the
bar code labels will not be concatenated.
If digit 10 is "t," digits 7, 8, and 9 are the decode
time limit in milliseconds. If both bar code labels
are not decoded in the same beam sweep within
this time, the bar code labels are not concatenated.
This time parameter is only accurate to a 25-
millisecond resolution.
Identifies the concatenation control as either the
distance "d" between bar code labels or the time "t"
in which concatenated bar code labels must be
decoded. See the description for Digits 7-9.
Trakker Antares 2400 Family System Manual