Menu System: Main Menu > Configuration Menu > Terminal Menu > Reader
Bar Codes: To disable or enable all the reader commands, scan one of these bar codes:
Or: To disable or enable specific reader commands, perform these steps:
Trakker Antares 2400 Family System Manual
Commands
Note: Before using the following scanning options, you must make sure
that the Enable Override option is not on. For help, see "Using the
Override Options" on page 161.
Disable All Reader Commands
*$+DC0*
*$+DC0*
1 Scan this bar code:
Enter Accumulate Mode / Command Processing
*+/$+DC*
*+/$+DC*
2 Scan the bar code to disable or enable one reader command.
Abort Program
*/$*
*/$*
Boot Terminal
*-.1*
*-.1*
Default/Save Configuration
*.+*
*.+*
Receive File
*.%*
*.%*
Reset Firmware
*-.*
*-.*
Scanner Trigger Off
*/%*
*/%*
Set Time and Date
*/+*
*/+*
Chapter 6—Configuration Command Reference
Enable All Reader Commands
*$+DC1*
*$+DC1*
Change Configuration
*$+*
*$+*
Delete File
*..--*
*..--*
Rename File
*...-*
*...-*
Run Program
*//*
*//*
Scanner Trigger On
*/.*
*/.*
Status Lights and
Sense Inputs Control
*$%*
*$%*
159