Intermec Trakker Antares 2410 System Manual page 273

Default: 0.0.0.0 (DHCP enabled)
Menu System: Main Menu > Configuration Menu > Communications Menu > Primary
Bar Codes: To set the default terminal IP address, scan this bar code:
Or: To set the terminal IP address:
Trakker Antares 2400 Family System Manual
Note: The RF or Ethernet network cannot be activated if the first address
segment in the IP address is set to 127 or a number greater than 223.
Note: If you are using the TCP/IP network, the default terminal IP
address enables the terminal as a DHCP client. For more information, see
"DHCP (Terminal)" on page 174.
Network
Default Terminal IP Address (DHCP enabled)
*$+ND0.0.0.0*
*$+ND0.0.0.0*
1 Scan this bar code:
Enter Accumulate Mode / Set Terminal IP Address
*+/$+ND*
*+/$+ND*
2 Scan a numeric value from 0 to 255 to set an n field of the terminal IP
address from these bar codes.
*0*
*0*
*2*
*2*
*4*
*4*
*6*
*6*
*8*
*8*
3 Scan this bar code:
. (Period)
*.*
*.*
4 Repeat Steps 2 and 3 to set the next three numbers in the terminal IP
address field. After you scan the last address segment, go to Step 5. Do
not scan the period after the last address segment.
Chapter 6—Configuration Command Reference
*1*
*1*
*3*
*3*
*5*
*5*
*7*
*7*
*9*
*9*
253