Intermec Trakker Antares 2410 System Manual page 332

Appendix D—Using Default and Optional Applications
312
Run EM9560.BIN
*/O/OC/ZEM9560/NBIN*
*//C:EM9560.BIN*
The terminal boots, resets all firmware, and runs the application. The
initial screen for the application appears. You see one of these screens:
APPTSK.BIN Screen
1998/01/00 12:00:00
If you are using a large font size or small column width, only the hours
and minutes will be displayed on the APPTSK.BIN initial screen. For
help, see "Display Spacing" on page 180.
2 Scan this bar code label to toggle the clock display on or off.
Toggle Clock Display
*CLOCKDISPLAY*
*CLOCKDISPLAY*
3 Use the application to scan bar code labels, enter data through the
keyboard, and transmit data.
This section lists some examples of how you can use the applications with
your Trakker Antares terminals.
Example 1
Use the application to troubleshoot and test communications before
loading and running your data collection application. Connect the
terminal to your network. Type data ("Hello World") on the Trakker
Antares terminal keyboard or scan a bar code label. The data is sent out to
all serial and network ports and should be received by the host if your
terminal is installed and configured correctly. Send data from the host and
verify that the data appears on the terminal screen.
Example 2
Connect a serial input device, such as a 1550 scanner, to a serial port on
the Trakker Antares terminal. Data from the input device is displayed on
the terminal screen and transmitted out the network (Ethernet or RF)
port.
39 AGaramond
nugget
EM9560.BIN Screen
Trakker Antares 2400 Family System Manual