Intermec Trakker Antares 2410 System Manual page 214

Chapter 6—Configuration Command Reference
Syntax: RYdata
Default: 5 seconds
Menu System: Main Menu > Configuration Menu > Communications Menu > Radio
Bar Codes: To set the default inactivity timeout to 5 seconds, scan this bar code:
Or: To set the inactivity timeout:
194
Power Management Tip: Intermec strongly recommends that you use the
optimum inactivity timeout of 5 seconds to preserve power.
Acceptable values for data are:
0 Radio never turns off
1-51 Inactivity timeout in seconds multiplied by a value of 5
where data=1 sets a timeout delay of 5 seconds, data=2 sets a timeout delay
of 10 seconds, and so on, up to data=51 for a timeout delay of 255
seconds.
Default Inactivity Timeout
*$+RY1*
*$+RY1*
1 Scan this bar code:
Enter Accumulate Mode / Set Inactivity Timeout
*+/$+RY*
*+/$+RY*
2 Scan a numeric value for data from these bar codes:
*0*
*0*
*2*
*2*
*4*
*4*
*6*
*6*
*8*
*8*
3 Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
*1*
*1*
*3*
*3*
*5*
*5*
*7*
*7*
*9*
*9*
Trakker Antares 2400 Family System Manual