Intermec Trakker Antares 2410 System Manual page 118

Chapter 5—Reader Command Reference
98
As you accumulate the data from bar code labels, the data is visible on the
bottom line of the screen. You can edit the accumulated data with the
Backspace, Clear, and Enter commands. If you are not in Accumulate
mode, these commands have no effect and you will hear an error beep.
When you exit Accumulate mode, the accumulated data is "entered" as
data records. Up to 250 characters can be held in the buffer. If the data
record count exceeds 250 characters, the data is truncated. If you reset the
terminal (software or hardware reset), you exit Accumulate mode, the
entire buffer is cleared, and all data accumulated is lost.
The syntax to use the Enter Accumulate command is:
+/data
where:
+/ is the syntax for the Enter Accumulate mode command.
data is the data you want to enter. This data can be a configuration
command or it can be a reader command that is executed when
you exit Accumulate mode.
Note: If you are using the advanced long range scanner or scan module,
you may not be able to scan the bar code labels in this manual. However,
you can still send commands through the serial port or network. For help,
see Chapter 2, "Configuring and Managing the Terminals."
To use Accumulate mode
1 Scan this bar code label to Enter Accumulate mode:
Enter Accumulate Mode
*+/*
*+/*
The Accumulate Mode screen appears.
Accumulate Mode
24XXS057.eps
Trakker Antares 2400 Family System Manual