Using The Keypad; Learning About The Bar Code Symbologies - Intermec Trakker Antares 2430 Quick Start Manual

C d 39 nuggetfont
2 Select Set-up Parms and press v. A password prompt
appears.
3 Type C R 5 2 4 0 1 and press v.
4 Select Protocol Opts, Data Stream, and then select the
appropriate TE 2000 configuration.
5 Save your changes by selecting Exit Menus from the
TE 2000 main menu. Press Y, and type C R 5
2 4 0 1 at the Enter Password prompt.
For information about using TE 2000 terminal emulation, see
the appropriate TE 2000 guide listed on page 19.

Using the Keypad

Characters, symbols, and functions are printed in four places on
or above the keys. The keypad overlays are also color-coded to
make it easier to remember key combinations.
Using the Keypad
Position on the Keypad
Printed on the key
Left side above the key
Centered above the key
Right side above the key
You can also use the arrow keys to move around an application
screen. To go up or down the screen, press u or d. To go left or
right, press a or b.

Learning About the Bar Code Symbologies

Although the 243X can decode many types of bar code
symbologies, only three symbologies are enabled when you
unpack the terminal: Code 39, Code 128, PDF417 (PDF417
tethered scanner only), and UPC/EAN. You need to configure
the terminal to decode the bar code symbology used in your bar
Trakker Antares 243X Handheld Terminal Quick Start Guide
Color To Type the Character
Press the key.
Press the l key, and then
Orange
press the key.
Press the w key, and then
Pink
press the key.
Press the r key, and then
Blue
press the key.
15