Using the Bar Code Scanner
This section applies only if your TRAKKER T2090 has an
integrated bar code scanner. The application software running
on the unit controls when the bar code scanner is activated.
To scan a bar code:
1. Hold the unit between 1-20 inches from the bar code label.
2. Press and hold the ENTER key. Make sure the red scanner
beam spans the entire bar code. (See the picture below.)
When the scanner is activated, the LED displays red.
Releasing the key prior to a successful 'read' will turn off the
scanner and the LED.
If the bar code is read successfully, the LED indicator turns green
for one second. You will also hear a beep if the unit's audible
feature has been enabled. If the bar code is not read successfully,
the LED indicator turns red for one second. You will also hear a
buzz if the unit's audible feature has been enabled.
Note: The readability of a bar code depends on the type of bar code
symbology, distance, and the condition or clarity of the printed
material.
9