Intermec Trakker Antares 2410 System Manual page 211

Syntax: YJn.data
Default: No characters (Disabled)
Menu System: Main Menu > Configuration Menu > Communications Menu > Serial
Bar Codes: To disable handshake, scan one of these bar codes:
Or: To enable handshake, scan one of these bar codes:
Trakker Antares 2400 Family System Manual
where n is:
1 COM1 serial port
2 COM2 serial port (246X and 248X terminals only)
3 COM3 serial port (242X terminals only)
4 COM4 serial port (242X, 2455, and 248X terminals only)
An acceptable value for data is any ASCII character.
Disabled No characters, no ACK or NAK transmitted
Enabled \x06 (hexadecimal value for ACK)
Port
Note: To scan these bar code labels, you must configure the terminal to
use Code 39 in Full ASCII mode. For help, see "Code 39" on page 146.
Disable Handshake for COM1
*$+YJ1.*
*$+YJ1.*
Disable Handshake for COM3
*$+YJ3.*
*$+YJ3.*
Enable Handshake (Set to ACK) for COM1
*/D/KYJ1/N$F*
*$+YJ1.$F*
Enable Handshake (Set to ACK) for COM2
*/D/KYJ2/N$F*
*$+YJ2.$F*
Enable Handshake (Set to ACK) for COM3
*/D/KYJ3/N$F*
*$+YJ3.$F*
Enable Handshake (Set to ACK) for COM4
*/D/KYJ4/N$F*
*$+YJ4.$F*
Chapter 6—Configuration Command Reference
Disable Handshake for COM2
*$+YJ2.*
*$+YJ2.*
Disable Handshake for COM4
*$+YJ4.*
*$+YJ4.*
191