Keypad Type Configuration Command; Keypad Table Diagnostic - Intermec Trakker Antares 2410 System Manual

Bar Codes: To set the default time zone, scan this bar code:

Keypad Type Configuration Command

Terminals: 243X
Description: The keypad type is initially configured in the terminal's firmware at the
Syntax: KTdata

Keypad Table Diagnostic

Trakker Antares Firmware Version 8.02 Addendum
Set Time Zone to Pacific Standard Time
*$+DZ-8*
*$+DZ-8*
Note: To set the time zone to a value other than the default value, use
Wavelink Avalanche.
Intermec factory. If you change the keypad overlay, you need to configure
the keypad type to match the new keypad overlay.
where acceptable values for data are listed in the next table. These
additional values are available for the 243X 48-key keypad.
Keypad Type Acceptable Values for Data
Value Description
a Programmable, 48-key, 243X
b International, 48-key, 243X
c TE 2000, 48-key, 243X
The keypad table diagnostic helps Intermec service personnel to identify
the number of the keypad table that you have loaded on your terminal.
The hexadecimal (hex) code displayed on the screen indicates which
keypad table is loaded. The following hex codes identify keypad tables for
the 243X 48-key keypad.
Keypad Table Hex Code Description
Hex Description
0x35 Programmable, 48-key, 243X
0x36 International, 48-key, 243X
0x37 TE 2000, 48-key, 243X
11