Intermec Trakker Antares 2410 System Manual page 113

Error Numbers and Messages (continued)
Error
Number Message
0xC0 IP format 0.x.x.x or 127.x.x.x
0xC1 Controller and device IP same
0xC2 Default router and device IP same
802.1x Security Error Numbers and Messages
Error
Number Message
0x0370 An encryption key with an invalid replay
counter has been received and discarded.
0x0371 An encryption key with an invalid key hash
has been received and discarded.
0x0372 An encryption key with an unrecognized
decode algorithm has been received and
discarded.
0x0374 A challenge for a security protocol that is
not supported in the terminal was received
and rejected.
0x0375 An error occurred while trying to send an
Extensible Authentication Protocol (EAP)
response. No buffer could be obtained, or
the output queue was full, so the response
was not sent.
0x0376 An invalid or unrecognized Extensible
Authentication Protocol (EAP)frame was
received and discarded.
0x0377 The authenticator rejected the terminal.
The most likely cause is that the user name
or password is incorrect.
0x0378 The CACERT.PEM file could not be
loaded from drive C on the terminal. The
file is either not on drive C, or it is too
large.
0x0379 The active application on the terminal
cannot be successfully reloaded after
authentication.
Trakker Antares 2400 Family System Manual
39 AGaramond
nugget
Error
Number
0xC3
0xC4
0xC5
This table lists the error numbers that are posted by the security code in
the terminal and lists the message associated with each number. You can
use this information to help you interpret the errors logged for the
terminal.
Chapter 4—Running Diagnostics
Message
Default router not on device network
IP and Subnet invalid
Configuration set timeout
Error
Number Message
0x037A The 802.1x state machine on the terminal was
unable to handle an event.
0x037B The 802.1x "Authenticating" state has timed out.
A likely cause is a breakdown in the
communications between the terminal and the
authentication server.
0x037C An error occurred while trying to send an EAP
response. The output queue was full, so the
response was not sent.
0x037D The application running on the terminal is not
compatible with the authentication process.
0x037F The root certificate exceeds the maximum size of
3K.
0x0509 The time and date on the terminal predates the
range of valid dates for the server certificate.
0x050A The time and date on the terminal postdates the
range of valid dates for the server certificate.
0x0513 The root certificate authority certificate on the
terminal cannot validate the server certificate. The
server certificate is either invalid, improperly
installed, or issued by a foreign certificate
authority.
0x0518 There is a problem with the intermediate
certificate authority. It cannot be used to validate
the server certificate.
93