Intermec Trakker Antares 2410 System Manual page 185

Syntax: NQdata
Default: 35 seconds
Menu System: Main Menu > Configuration Menu > Communications Menu > Advanced
Bar Codes: To set the default controller connect check send timer, scan this bar code:
Or: To set the controller connect check send timer:
Trakker Antares 2400 Family System Manual
Power Management Tip: Intermec strongly recommends that you use the
optimum setting of 35 seconds.
Acceptable values for data are any number from 1 to 3600 seconds (60
minutes).
Network
Default Controller Connect Check Send Timer
*$+NQ35*
*$+NQ35*
1 Scan this bar code:
Enter Accumulate Mode / Set Controller Connect Check Send Timer
*+/$+NQ*
*+/$+NQ*
2 Scan a numeric value for data from these bar codes:
*0*
*0*
*2*
*2*
*4*
*4*
*6*
*6*
*8*
*8*
3 Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Chapter 6—Configuration Command Reference
*1*
*1*
*3*
*3*
*5*
*5*
*7*
*7*
*9*
*9*
165