Intermec Trakker Antares 2410 System Manual page 139

From Network:
Keypad or Menu: Not supported
Scan: Follow these steps:
Trakker Antares 2400 Family System Manual
Trakker Antares applications are 8-bit binary files. Some network
protocols like the Intermec Multi-Drop protocol in a CrossBar network
use 7-bit ASCII files. When you send 8-bit binary files across a 7-bit
system without converting the files, the files are not compatible and will
not run.
You use the Transmit File command and a host utility to convert the 8-bit
binary file to a 7-bit ASCII hexadecimal file and transfer it from the
terminal. On the host, you use a hexadecimal conversion utility to convert
the 7-bit ASCII hexadecimal file to an 8-bit binary file. Intermec has a
DOS utility called HEX.EXE to convert files. The source code for
HEX.EXE is also available. For help, see your Intermec service
representative.
Note: Trakker Antares filenames are up to eight characters with a three-
character extension. Files you transfer from the host must use the Trakker
Antares naming conventions.
%%Hn,drive:filename
where:
is the command to convert an 8-bit binary file to a 7-bit ASCII
%%H
hexadecimal file and transmit it. The terminal uses the current
serial port configuration (protocol, baud rate, etc.) for the file
transfer.
indicates the terminal's serial port: 1, 2, or 4.
n
drive: indicates the drive where the file is stored on the terminal. You
must include the colon (:) after the drive letter.
filename is the file you want to transmit.
Note: To scan these bar code labels, you must configure the terminal to
use Code 39 in Full ASCII mode. For help, see "Code 39" on page 146.
1 Scan this bar code label:
Enter Accumulate Mode / Transmit File
*/K/O/E/EH*
*+/%%H*
2 Scan the bar code label for the terminal COM port you are using to
transmit the file. The label also includes the required comma.
COM1
*1/L*
*1,*
Chapter 5—Reader Command Reference
COM2
*2/L*
*2,*
COM4
*4/L*
*4,*
119