Intermec Trakker Antares 2410 System Manual page 282

Chapter 6—Configuration Command Reference
Syntax: CEdata
262
To define the UPC/EAN symbology, you set up to seven digits. The
supplemental portion of a UPC or EAN label is a weak symbology and can
be missed by the scanner for several reasons. In situations where
supplementals are known to be present, reading just the main symbol can
be prevented until a valid supplemental is found. When using a laser
scanner, performance degradation is not noticeable.
The fifth, sixth, and seventh digits are optional. To set the sixth digit, you
must set the fifth digit. To set the seventh digit, you must set all seven
digits.
where data must be 4 to 7 digits selected from this list:
Digit 1: 0
1
2
Digit 2: 0
1
2
Digit 3: 0
1
Digit 4: 0
1
2
3
4
Digit 5: 0
1
Digit 6: 0
1
Digit 7: 0
1
Note: E1022 linear imagers and later versions of integrated PDF417 and
1551 scanners do not support transmitting a number system digit for
EAN-8. For help upgrading your scanner, contact your local Intermec
service representative.
UPC-A/EAN-13 disabled
UPC-A/EAN-13 enabled
UPC-A only enabled
UPC-E disabled
UPC-E enabled
Expanded zeroes
EAN-8 disabled
EAN-8 enabled
Supplementals not allowed
Supplementals allowed
Supplementals required
Two-digit supplementals required
Five-digit supplementals required
Discard check digit
Transmit check digit
Discard number system digit
Transmit number system digit
Discard the leading zero for UPC-A
Retain the leading zero for UPC-A
Trakker Antares 2400 Family System Manual