Chapter 2: Shapeshiftersetup And Configuration; Installation Of Your Shapeshifter Fixture Includes Mounting, Connecting To; Unpacking The Fixture; Pan And Tilt Locking - High End Systems Shapeshifter C1 User Manual

Chapter 2: SHAPESHIFTER
Setup and Configuration
Installation of your SHAPESHIFTER fixture includes mounting, connecting
to power, DMX linking and configuration.
Use the following steps to set up and configure your fixture:
1. Unpack the fixture.
2. Install power cord cap for your location.
3. Mount the fixture upright or suspended from a standard truss.
4. Connect the fixture to a DMX controller via DMX cabling.
5. Configure the fixture for DMX control.

Unpacking the Fixture

The SHAPESHIFTER fixture ships in packaging specifically designed to protect the product during
transport. When unpacking, inspect the fixture for physical damage to components. High End
Systems assumes no responsibility for products that are damaged during transport. Return a
®
product for repair in its original packaging.
Before sending anything to the factory, call your High End Systems dealer/distributor
for a Return Material Authorization (RMA) number. The factory cannot accept any goods
shipped without an RMA number.

Pan and Tilt Locking

The SHAPESHIFTER fixture ships with pan and
tilt latches locked. You can unlock/adjust these
latches to stabilize the fixture for mounting.
Note: Always disengage Pan and Tilt locks
before operating the fixture.
SHAPESHIFTER User Manual
Pan Lock
Tilt Lock
5