Installing A Power Cord Cap; Installing A Line Cord Cap - U.k. Only; Vatic Fitter Heads Information - Danmark - High End Systems Shapeshifter C1 User Manual

CHAPTER 2
SHAPESHIFTER Setup and Configuration

Installing a Power Cord Cap

The power cord for SHAPESHIFTER fixtures ships without a power cord cap. Use the information in
this section to install the correct power cord cap for your location.
Because of the variety of power cord caps used worldwide, High End Systems, Inc. cannot make
specific recommendations for the power cord cap. Contact a local authority for the type of power
cord cap needed. When installing the power cord cap, note that the cores in the mains lead are
colored according to the following code:
• green and yellow = earth
• white = neutral
• black = live

Installing a Line Cord Cap - U.K. Only

In the United Kingdom, core colours in the mains lead of this equipment may not correspond with
the colored markings identifying the terminals in the fixture's plug. In that case, install a line cord
cap in accordance with the following code:
• Connect the green and yellow core to the plug terminal marked with the letter "E," or by the
earth symbol
• Connect the white core to the terminal marked with the letter "N" or coloured black.
• Connect the black core to the terminal marked with the letter "L" or coloured red.
WARNING:
Class 1 equipment - This equipment must be earthed.

Vatic Fitter Heads Information - Danmark

Advarsel: Beskyttelse mod elektrisk chock.
Vigtigt!
Lederne med gul/groen isolation maa kun tilsluttes en klemme maerket
6
or coloured green, or green and yellow.
eller
SHAPESHIFTER User Manual