Default Trunk And Station Numbering - Samsung OfficeServ500 Installation Manual

Default Trunk and Station Numbering

On initial power up, the MCP2 card reads each slot for the existence of a card and identifies the
type of card. It stores this information as the default configuration. The trunk card in the lowest
slot number is assigned trunk numbers beginning with 701. The next highest slot number with a
trunk card is assigned trunk numbers following those of the first trunk card. This numbering se-
quence continues until the last trunk card in the highest slot number is assigned the last trunk
number.
For example, if an 8TRK card is in the first slot, port C1/S1/P1 is assigned trunk number 701
(first cabinet, first slot, first trunk in the system). If the second slot has a Trunk B card installed,
port C1/S2/P4 is assigned trunk number 712 (first cabinet, second slot, fourth circuit, 12th trunk
in the system).
Station numbers are assigned in the same manner. The lowest slot number containing any type
of station card is assigned station numbers beginning with 201. The next highest slot with a sta-
tion card is assigned numbers following those of the first station card. This numbering sequence
continues until all of the stations are assigned. Default data assigns the keyset in the lowest port
to the operator group and all trunks ring that station until the default is changed. It is recom-
mended that the first station card be a DLI card so that the operator station will default to a key-
set as extension 201. Using MMC 724, station and trunk numbers can be changed, rearranged
and reassigned as needed.
NOTE: Newly added station or trunk cards come up without directory numbers. The above
examples describe a system using a three-digit numbering scheme. If the DIP switches on
the MCP2 card are changed, the default numbers may be four digits. See
Processor Card (MCP2) in Chapter 4 for details of DIP switch settings.
5-3
Main Control