Operation Mode; Channel Selection Mode; Setup Mode - Fuji Electric Micro Control X Instruction Manual

Power ON
Operation
mode
PV/SV display
(Operation
screen)
Channel
selection mode
Press
and hold

Setup mode

Operation mode

In this mode the normal operation is performed. The process value (PV) and the set value (SV) are displayed. The device starts in this mode when you turn on the
power. You can change the set value (SV) in this mode. You can check the output value (MV) and the amount of electric ower by switchin the screen.
Operation control mode
In this mode you can put the device to standby or change the alarm set value.

Channel selection mode

In this mode you can select the parameter channel to be displayed.
Setup mode
In this mode you can setup each parameter. This mode includes the parameter selection submode and the parameter editing submode, which can be switched by
values by using keys.
1
lit).
Change the SV with the keys.
2
Press the key to save the values.
3
(The value will be automatically saved after 3 seconds even if a key is not pressed.)
PV/MV display
Operation
Press
control mode
and hold
in the selected channel
Parameter
ex) ch1 PID
d
i
P
PV/power
Parameter
AUTO/MANUAL
keys. In the parameter editing submode, you can change parameter
1
Switch to manual mode.
2
(Pressing the
Change the MV with the
3
Channel
keys.