Analog Signal Output; Gpib Interface; Can Interface; Remote Interface - Agilent Technologies 1100 Series Reference Manual

Analog Signal Output

The analog signal output can be distributed to a recording device. For details
refer to the description of the module's main board.

GPIB Interface

The GPIB connector is used to connect the module with a computer. The
address and control switches next to the GPIB connector determine the
GPIB address of your module. The switches are preset to a default address and
recognized by the operating software from Aligent Technologies.
Table 37
Autosampler
Pump
FLD
VWD
Agilent 8453
DAD/MWD
Column Compartment

CAN Interface

The CAN is an intermodule communication interface. It is a 2-wire serial bus
system supporting high speed data communication and real-time requirement.

Remote Interface

The APG remote connector may be used in combination with other analytical
instruments from Aligent Technologies if you want to use features such as
common shut down, prepare, and so on.
1100 Series DAD and MWD Reference Manual
Default Addresses
28
22
23
24
25
26
27
Introduction to the Detector
Autosampler
RID
Autosampler (HP 1050)
Pump (HP 1050)
VWD (HP 1050)
DAD (HP 1050)
6
28
29
18
16
10
17
257