Entering The Serial Number Using The Control Module - Agilent Technologies 1100 Series Reference Manual

4 Repairing the Detector

Entering the Serial Number using the Control Module

1 Connect the control module to the detector. Turn on the detector.
2 In the control module, press System (F5), then Records (F4). Using the
3 Press FW Update (F5). Now, press the m key. This will display a box which
4 Press Enter. This will display the box labeled Serial#.
5 Alphabetic characters and numbers are created using the up and down
For firmware revisions below A.02.00 it is important never to press Done if the Serial# box
N O T E
is blank. In this case, the module can no longer be recognized by either the control module
or the Agilent ChemStation. The main board must then be replaced.
6 Turn the detector off, then on again. The Records screen should display the
7 If a Agilent ChemStation is also connected, restart the Agilent ChemStation
146
up/down arrows, make sure that the detector is highlighted.
says Update Enter Serial#.
arrows. In the box labeled Serial#, enter the 10-character serial number for
the detector. When the 10-character serial number is entered, press Enter
to highlight the complete serial number. Then, press Done (F6).
correct serial number for this module.
now as well.
1100 Series DAD and MWD Reference Manual