Lan Communication Interface Board - Agilent Technologies 1100 Series Reference Manual

LAN Communication Interface Board

One board is required per Agilent 1100 stack. It is recommended to add the LAN board to
N O T E
the detector with highest data rate.
The LAN board can only be used together with:
N O T E
a main board version G13XX-66520 (for G1315A, G1365A, G1314A, G1310A, G1311A,
G1312A and G1313A) or newer and on all other 1100 modules.
a DOS-ChemStation software revision A.06.01 or above.
The following cards can be used with the Agilent 1100 modules.
Table 35 LAN Boards
Type Vendor
G1369A Agilent Technologies
G1369-60001
J4106A (*) Hewlett Packard
J4105A (*) Hewlett Packard
J4100A (*) Hewlett Packard
These cards (*) may be longer orderable. Minimum firmware of these Hewlett Packard
N O T E
JetDirect cards is A.05.05.
Recommended Cables
1100 Series DAD and MWD Reference Manual
Supported networks
Fast Ethernet, Ethernet/802.3, RJ-45 (10/100Base-TX)
recommended for re-ordering
Ethernet/802.3, RJ-45 (10Base-T(
Token Ring/802.5, DB9, RJ-45 (10Base-T)
Fast Ethernet, Ethernet/802.3, RJ-45 (10/100Base-TX) + BNC (10Base2)
Cross-over network cable (shielded, 3 m long),
(for point to point connection)
Twisted pair network cable (shielded, 7 m long)
(for hub connections)
Introduction to the Detector
5023-0203
5023-0202
6
255