Status indicator
green/yellow/red
Line power switch
with green light
Figure 5
4 Connect the power cable to the power connector at the rear of the detector.
5 Connect the CAN cable to other Agilent 1100 Series modules.
6 If a Agilent ChemStation is the controller, connect either
If a Agilent 1100 DAD/MWD/FLD is in the system, the LAN/GPIB should be connected to
N O T E
the DAD/MWD/FLD (due to higher data load).
7 Connect the analog cable(s) (optional).
8 Connect the APG remote cable (optional) for non-Agilent 1100 Series
9 Turn on power by pushing the button at the lower left hand side of the
1100 Series DAD and MWD Reference Manual
Front View of Detector
•
the GPIB cable to the detector or
•
the LAN connection to the LAN interface board in the detector.
instruments.
detector. The status LED should be green.
Installing the Detector
1
23