4
Repairing the Detector
Removing the Optical Unit (G1315B/G1365B)
When required
Tools required
Parts required
With the introduction of the G1315B/G1365B DAD/MWD the appearance of the z-plane
N O T E
(front metal plane) has been changed (no holes any more) and an isolation seal between
the optical unit and the z-plane. Therefore, some of the figures may still show the old
appearance of the G1315A/G1365A. For G1315A/G1365A detectors refer to
Optical Unit (G1315A/G1365A)"
Preparations for this procedure:
•
Turn off the lamp.
•
Switch off detector, and disconnect power cable.
•
Remove detector from stack and place it on working
bench.
•
Remove front cover, top cover and top foam section, see
"Removing the Top Cover and Foam"
156
For all repairs inside the optical unit
Screwdriver POZI 1 PT3
Optical unit G1315-69002 (exchange assembly) or
Individual parts depending on the following procedures
on page 154.
1 .Loosen the screw on the left side of the z-plane and the
on page 140.
two screes near the hydraulic connection.
1100 Series DAD and MWD Reference Manual
"Removing the