Agilent Technologies 1100 Series Reference Manual page 24

1 Installing the Detector
Interface board
Analog signal
APG remote
RS-232C
Figure 6
The detector is turned on when the line power switch is pressed and the green indicator
N O T E
lamp is illuminated. The detector is turned off when the line power switch is protruding and
the green light is off.
To disconnect the detector from line, unplug the power cord. The power supply still
WA R N I N G
uses some power, even if the power switch at the front panel is turned off.
The detector was shipped with default configuration settings. To change these settings see
N O T E
"Setting the 8-bit Configuration Switch"
24
Rear View of Detector
GPIB
CAN
Configuration switch
on page 261.
1100 Series DAD and MWD Reference Manual
Security lever
Power