Interfaces - Agilent Technologies 1100 Series Reference Manual

6 Introduction to the Detector

Interfaces

The Agilent 1100 Series modules provide the following interfaces:
Table 36 Agilent 1100 Series Interfaces
Interface Type Pumps
CAN Yes
GPIB Yes
RS-232C Yes
Remote Yes
Analog Yes
Interface board Yes
* The vacuum degasser will have a special connector for specific use. For details see description of main board.
• CAN connectors as interface to other Agilent 1100 Series modules,
• GPIB connector as interface to the Agilent ChemStation,
• RS-232C as interface to a computer,
• REMOTE connector as interface to other Agilent products,
• Analog Output connector(s) for signal output, and
• Interface slot for specific interfacing (external contacts, BCD, LAN and so
For identification and location of the connectors
Never use cables other than the ones supplied by Aligent Technologies to ensure
WA R N I N G
proper functionality and compliance with safety or EMC regulations, see
Overview"
256
Autosampler
Yes
Yes
Yes
Yes
No
Yes
on).
on page 210.
DA Detector VW Detector
MW Detector RI Detector
FL Detector
Yes Yes
Yes Yes
Yes Yes
Yes Yes
2 × 1 ×
Yes Yes
1100 Series DAD and MWD Reference Manual
Thermostatted Vacuum
Column Degasser
Compartment
Yes No
Yes No
Yes No
Yes Yes
*
No Yes
No No
Figure 6 on page 24.
"Cable